Women's Warm and Airtight Ski Suit 500-Navy Blue
Store Availability
Store availability
BENEFITS
Adjustable
Adjustable hood, adjustable waist, removable collar.
Warmth
Insulation in 60 G/m² wadding on legs and arms, 100 g/m² on chest.
Waterproof
10,000 mm membrane (Schmerbers) and taped seams.
Pockets
6 : 2 Thigh pockets, 2 hand pockets, 1 ski pass pocket, 1 inner chest pocket
Breathability
Breathable main fabric RET 12.
Limits snow entering
Hood, wrist fastenings, cuffs, ankle gaiters.
TECHNICAL INFORMATIONS
What is a membrane and what's it for?
The membrane is a very fine component applied to the inner surface of the outer jacket fabric. This hydrophilic component prevents water from seeping in while wicking away the perspiration produced by the body. The membrane is unbeatable when it comes to staying warm and dry.
How is the water resistance of a ski suit measured?
The resistance of a fabric is measured by the height of a water column in mm that can be supported by the fabric (test based on the ISO 811 standard). The higher the pressure, the more waterproof the fabric. A component with a water resistance of 8000mm therefore withstands the pressure exerted by 8000mm of water.
What is the water repellent feature of my jacket for?
The water-repellent property of a fabric is its capacity to allow water to run off its surface without seeping in. This jacket features water-repellent components that extend its weather resistance. The fabric is made water-repellent by treating its outer surface. However, this property may deteriorate with use.
How can you reactivate the water-repellency of your jacket?
Bear in mind that the water-repellent feature can be reactivated. To do this, you can use a waterproof spray (sold in our stores): spray the product evenly over the entire garment, then leave it to dry for 10 to 12 hours).
What is a "breathable" jacket?
This garment wicks away the water vapour produced by your body when exercising. To see if a fabric is breathable, its resistance to evaporative heat (RET) is measured in a standardised ISO 11092 test. The lower the RET, the more breathable the fabric. The jacket 500 has an RET of 11. However, it is the technical solutions (zips, vents, mesh) that Wedze uses, which reduce the condensation inside the garment and maximise breathability.
How to dress to stay warm on the slopes?
To make sure you stay warm and dry, we recommend using the 3-technical-layer rule:
- Layer 1 or a second skin, to stay dry.
- Layer 2 or an insulating layer, to keep the heat in.
- Layer 3 or a protective layer to protect against the elements.
How do I wash my salopettes?
Dry in a tumble dryer (strongly recommended)
* Use a gentle or delicate programme.
* Dry on several long cycles to dry completely.
* If you do not have a tumble dryer, it will take longer to dry. (drying can take 1 to 2 weeks on a dry and flat place). Make sure you pat the jacket to avoid any lumps
This product is repairable
This product is repairable. We commit to repairing your product free of charge for the duration of the warranty. Whatever it is, fixings, seams, zips, etc. This service is offered in your usual store. However, if we can't repair your product (production defect), we will exchange it or reimburse you.
To help you choose the right size
The model is wearing size M and is 1.73 m tall
Their measurements are as follows:
- Chest circumference 85cm
Arm length 57cm (from shoulder bone to wrist)
- Waist circumference 67cm
Inside leg 83cm
- Hips 99cm
COMPOSITION
composition
Main fabric: 100.0% Polyester; Filling: 100.0% Polyester; Membrane: 100.0% Polyurethane; Main lining: 100.0% Polyamide; Yoke: 29.0% Polyurethane, 71.0% Polyester; Secondary lining: 100.0% Polyester; Main fabric - Bottom: 100.0% Polyamide; Pocket lining: 100.0% Polyester; Collar: 8.0% Elastane, 92.0% Polyester; Lining: 12.0% Polyamide, 88.0% Polyester; Cuff: 85.0% Polyester, 15.0% Polyester; Ventilation: 100.0% Polyester
Tips for storage and maintenance
MAXIMUM WASH TEMPERATURE OF 30°C. VERY MODERATE TREATMENT.
BLEACHING EXCLUDED.
DRYING IN TUMBLE DRYER POSSIBLE. LOW TEMPERATURE, MAXIMUM DRUM EXHAUST TEMPERATURE 60°C.
DO NOT IRON.
DO NOT DRY CLEAN.
Storage tips
Store on a hanger and do not fold, as this can damage the fabric's water-resistance. Dry thoroughly before storing in a dry and well-ventilated place.
TESTS AND WARRANTY
Test product
All Wedze products are conceived, designed and developed in the Mont Blanc Valley. They are then tested under identical usage conditions to those you will encounter yourself (in the snow, cold and powder snow, etc.). The design teams make sure the programme for which the product is designed and developed tallies perfectly with its real-world use.
Warranty
2 Years
Ecodesign approach
With ecodesign, we reduce the environmental impact of our products.
Analysing the product's environmental footprint enabled us to identify the most impactful stages of its life cycle. Thanks to this approach, our design teams were able to develop this product while significantly reducing its environmental impact.
Ecodesign actions on this product
-
ProcessGreige
Product made from 21% undyed yarn
Using this finishing process enables us to reduce CO2 emissions linked to the production of undyed textiles by at least 53% compared to conventional dyeing.
-
Process
Greige
Product made from 21% undyed yarn
Using this finishing process enables us to reduce CO2 emissions linked to the production of undyed textiles by at least 53% compared to conventional dyeing.
-
MaterialRecycled polyester
Product made from 28% recycled polyester
Using recycled polyester rather than conventional polyester reduces the CO2 emissions linked to the material by at least 17%.
-
ProcessDope dyed
Product made from 49% dope dyed yarn
Using this mass-dyeing process enables us to reduce CO2 emissions linked to the production of dyed textiles by at least 17% compared to conventional dyeing.
-
Process
Dope dyed
Product made from 49% dope dyed yarn
Using this mass-dyeing process enables us to reduce CO2 emissions linked to the production of dyed textiles by at least 17% compared to conventional dyeing.
-
Process
Greige
Product made from 21% undyed yarn
Using this finishing process enables us to reduce CO2 emissions linked to the production of undyed textiles by at least 53% compared to conventional dyeing.
-
Process
Dope dyed
Product made from 49% dope dyed yarn
Using this mass-dyeing process enables us to reduce CO2 emissions linked to the production of dyed textiles by at least 17% compared to conventional dyeing.