Surfing inflatable SUP minimalibu 500 / 9" 120L

Recommended user weight

Recommended user weight:



Less than 50 kg: the ideal board for easily getting into SUP surfing

Between 50 and 65 kg: board suitable for intermediate SUP surfers

Over 65 kg: board for advanced users only



Maximum load to stay above the water: 95 kg.

Inflated shape and dimensions

ITIWIT's SURF SUP 9' is a MINI MALIBU board: with a round nose and round pintail, it is similar to a longboard, only smaller!

Ideal for surfers who like to carve smooth curves in the waves.

Length: 9' (274 cm)

Width: 28" (71 cm)

Thickness: 3" (7.5 cm)

Volume: 120 litres

Board weight: 7.6 kg

Inflating & deflating the stand-up paddleboard

INFLATION

This SUP is equipped with a NEW GENERATION valve for even greater security.

To inflate your SUP, open the cover and connect the pump (“IN” mode).

Inflate to 17 psi for best results.

Disconnect the pump and close the exterior cover



DEFLATING

Turn the cover a quarter clockwise (“out” mode).

Roll up starting from the side opposite to the valve to remove all the air to completely fold

Close the cap

Installing and removing the fin

This surf SUP has a "SINGLE FIN" set-up. This means it has one fin (ref: 8576512) installed on the centre line of the board. We chose this type of set-up for better HANDLING of the surf SUP in the waves



NB: Remember to remove the fins once you get out of the water.

If possible, rinse the fin base before and after use.

Carry bag

Two-tone fabric bag (see ''DEVELOPMENT ADDITIONAL INFORMATION'' section to find out more)



Height: 90 cm

Width: 35 cm

Thickness: 20 cm

approx. 63 L

These dimensions leave room for a pump and paddle.



Interior pocket and compression system included

LEASH

Always wear your leash to stay attached to your board if you fall. It’s best to attach it to your ankle, but it can also be attached to the knee.

Remove it and rinse after each use.

PLEASE NOTE: do not use a leash on rivers

Folding the board

Empty all the air from the board

Start folding up from the fin base, following the dotted lines to avoid damaging the base.

Stop halfway and start a second folding beginning from the valve side (wallet folding).

OUR BOARDS CAN BE REPAIRED!

The vast majority of surfing stand up paddleboards are repairable:

For small repairs, we sell a stand-up paddle board repair kit, reference 8512384.

For more complex repairs: we recommend contacting the workshop at your nearest store: valve, handle, fin box... our workshops can repair them all to prolong the life of your surf SUP

How to take off on a surf SUP

When a wave is approaching, position both of your feet on the white areas in the middle of the "dots" arranged symmetrically around the handle.

Start paddling and do not stop until you feel the wave lift you up.

Once you feel the wave pushing you along: move your back foot onto the orange area (right foot for REGULAR stance, left foot for GOOFY stance).

Ideally, your back foot should be on the foam arch in the orange area and your front foot in front of the handle