LEASH Bodyboard BICEPS 900 Black 8.5mm spiral
Store Availability
Store availability
BENEFITS
Anatomic design
Biceps diameter from 22 to 36cm, adjustable with hook and loop strap.
Compact design
Spiral cord for less clutter when paddling.
Easy opening / closing
Can be put on and taken off at the arm (biceps), with just one hand.
Robustness
Polyurethane cord, 8.5 mm diameter. Plug included (board thickness: 4.5 to 6cm)
TECHNICAL INFORMATIONS
We design products according to 4 levels of experience. This product is intended for intermediate and advanced users.
- Novices: Up to the navel, no fins, small waves < 50cm, propulsion by pushing your feet on the ground, then riding the wave to the shore. For a 1st wave-riding experience (bodyboard with grips).
- Beginner: Gentle turns in waves up to 1 m, propulsion with fins. A must for learning to bodyboard.
- Intermediate: Waves up to 1.50 m, more speed and the beginning of tricks (360°, El Rollo, etc.).
- Advanced: All types of waves, command of tricks, even aerial: ARS, 360°, tube...
How to use your advanced bodyboarding leash.
This leash attaches to the bodyboard using the leash plug provided or already present on your bodyboard. To use it, place the cuff above your elbow on the side of your choice. Bend your arm at 90° and tighten the strap with your other hand, securing it with the hook and loop strap. NOTE: The cuff of this leash is too wide to be attached at the wrist.
Suitable for all types of conditions: Advanced level.
The components chosen for this leash provide good durability in all types of waves. However, be careful not to put yourself in a dangerous situation due to a broken leash.
Always check the condition of your leash before the session and avoid prolonged UV exposure. Systematically rinse it and store it in a dry place in the shade.
Compact.
The benefit of a spiral leash is that it is compact and does not get in your way during practice. If this leash is stored for too long in a stretched position, the coil will relax and it will no longer be compact. It is therefore recommended to attach the adjustable end to the cord connected to the plug, using it and the rip-tab strap between each session. This will prevent the leash from stretching when not in use. See the illustration photo provided.
Where to install the leash plug on the bodyboard?
To install the plug on a bodyboard, first identify the correct location: Between 10 and 15 cm from the nose of the board and far enough away from any stringers.
If the board has 2 stringers, the plug must be central. If the board has a single stringer, the plug must be offset at least 5 cm from the middle of the board, on the right if you wear your leash on the right, or vice versa.
How to install the leash plug?
At the desired location, pierce a hole using a large Phillips screwdriver from below. (If you pierce from the top, you could damage the slick by lifting it off).
Insert the 2 parts of the plug one after the other, with the screw at the bottom.
Screw it in using a £2/€2 coin until the slick warps slightly.
Safety and behaviour rules for the water - Part 1.
Bodyboarding is a fantastic sport, but one that requires everyone to respect certain basic rules to ensure the safety and enjoyment of all.
1- Ask about and observe the characteristics of the spot: current, rocks, tidal influence, size of the waves and number of people in the water, etc.
2- Don’t overestimate your level, and go for an easier spot if your skills don't match up to the conditions.
3- Use suitable equipment: Leash, fins and board in good condition, suitable wetsuit.
Safety and behaviour rules for the water - Part 2.
4- Respect the rules of right of way on the waves: Right of way goes to the person closest to the peak.
5- Avoid the breaking wave area when moving back up to the peak to avoid cutting another boarder off.
6- Use fins if the water is above your hips.
7- If you’re not using fins, it’s recommended you keep to a supervised area. Lifeguards can tell you where these are.
8- Bodyboard in a group.
COMPOSITION
composition
Main fabric: 100.0% Polyurethane
Tips for storage and maintenance
DO NOT WASH.
BLEACHING EXCLUDED.
DO NOT TUMBLE DRY.
DO NOT IRON.
DO NOT DRY CLEAN.
Storage tips
Rinse and dry in a dry and well-ventilated place after use.
TESTS AND WARRANTY
Test product
Developed and tested by our bodyboard-loving design teams in Hendaye, France. The components used for this product are laboratory-tested to ensure the best possible quality and durability.
Warranty
2 Years
Agree by
Our technical partners: Lionel Medina; Ethan, Noah and Nicolas Capdeville; Yvon and Mael Martinez; Victor Le Gleut.