Indoor Climbing Rope by the Metre 10 mm - Indoor Blue

TREATMENT FOR BETTER FLUIDITY

This rope features a plasma treatment which helps to improve the rope's smoothness when feeding it through karabiners and belay devices.

MIDDLE MARKING

To improve your safety, this rope features a black mark which indicates the middle of the rope.

Total weight

66 g/m



PLEASE NOTE: Weight measurements made according to the EN 892 standard.

For example, for a single rope, the rope must be exposed to 10 kg of tension for 1 minute in very precise temperature and moisture conditions.

This gives you the real weight of the rope, which is often superior to the weight given by the standard.

The weight measurement according to the standard is used to compare two ropes to each other.

TECHNICAL FEATURES OF THE ROPE

This rope obtained the following results in standard tests from an APAVE certified laboratory (tests conducted on a fall length of 4 metres, factor 2, with 80 kg rigid mass):

Number of falls:7

Impact force: 870 DaN

DYNAMIC ELONGATION: 31.1%

STATIC ELONGATION: 6.3%

SHEATH SLIPPAGE: 0

NUMBER OF SPINDLES: 32

HOW TO CHOOSE THE RIGHT ROPE LENGTH

Note that the length of rope needed depends on the terrain as well as the height.

Be sure to check with the wall operator before climbing.



Additionally, as a rope ages—no matter the brand—it tends to expand and shrink. We recommend you re-measure regularly.

WASHING YOUR ROPE

To extend the lifespan of your rope, protect it from dirt. We recommend the following

1- use a rope tarp when it is on the ground

2- if it is dirty, wash it in clean, lukewarm water

Should stains persist, use a pH-neutral soap (such as Marseille/household soap) and rinse thoroughly with clean water

3- air dry it in the shade and away from all sources of heat.

STORING YOUR ROPE

Ropes should be stored in a cool, dry place, away from light, humidity, and corrosive agents. Never leave ropes inside a car during summer, for example.

CHECKING YOUR ROPE

It is important to check your rope regularly. To do so, run the rope through your hands and inspect it metre by metre along its entire length. This will allow you to spot any nicks, cuts, or weak spots. If you notice any anomalies or irregularities, if the core is visible in certain places, if the rope is deformed or has exceeded its fall rating, it must be changed. Take safety seriously!