UIAA DRY treatment:

This rope has UIAA Water Repellent label.

A brief summary of test:

- A rope sample is subjected to light abrasion over its entire surface, the equivalent to a few days’ use.

- It is soaked for 15 minutes.

- the amount of absorbed water must not be greater than 5% of the sample’s weight.

SIMOND DRY rope easily meets UIAA requirements



The rope's mechanical features will last longer in cold and wet conditions.

Ultrasound finishing:

Deterioration of rope ends is no longer an issue thanks to this new ultrasound fusion process.

Middle marking:

To improve your safety, this rope features a black mark which indicates the middle of the rope.

Technical features:

NUMBER OF FALLS: 5/15/35

IMPACT FORCE:7.9/6/9.5 KN

DYNAMIC ELONGATION: 32.3% / 29.7%/ 26.8%

STATIC ELONGATION: 8.2% / 8.2%/4.9%

SHEATH SLIPPAGE: 0

NUMBER OF SPINDLES: 40

Weight:

54 g/m



PLEASE NOTE: The weight is measured according to the EN 892 standard.

For example, for a single rope, the rope must be exposed to 10 kg of tension for 1 minute in very precise temperature and moisture conditions.

This gives you the real weight of the rope, which is often superior to the weight given by the standard.

The weight measurement according to the standard is used to compare two ropes to each other.

Washing your rope:

It's important to properly care for your rope to reduce wear.

Dirt causes rope to age prematurely, so we recommend:

1- use a rope tarp when it is on the ground;

2- If a rope is dirty, wash it in fresh, lukewarm water.

Should stains persist and you want to wash it with soap, it is important to use a pH-neutral soap (such as Marseille/household soap) and then rinse thoroughly with clean water.

3- Air dry the rope out of the sun and away from all sources of heat

Storing your rope:

Ropes should be stored in a cool, dry place, away from light, humidity, and corrosive agents. Never leave ropes inside a car during summer, for example.

Checking your rope:

It is important to check your rope regularly. To do so, run the rope through your hands and inspect it metre by metre along its entire length. This will allow you to spot any nicks, cuts, abrasion or weak points. If you notice any anomalies or irregularities, if the core is visible in certain places, if the rope is deformed or has exceeded its fall rating, it must be changed. Take safety seriously!