TRIBORD Ref. 8678296 4448810

Sailing Waterproof Anorak - Waterproof Windproof Anorak SAILING 100 blue DDY

€28.99
VAT included
  • Waterproof sailing jacket - wet-weather windproof jacket SAILING 100 navy blue
  • Waterproof sailing jacket - wet-weather windproof jacket SAILING 100 navy blue
  • Waterproof sailing jacket - wet-weather windproof jacket SAILING 100 navy blue
  • Waterproof sailing jacket - wet-weather windproof jacket SAILING 100 navy blue
  • Waterproof sailing jacket - wet-weather windproof jacket SAILING 100 navy blue
  • Waterproof sailing jacket - wet-weather windproof jacket SAILING 100 navy blue
  • Waterproof sailing jacket - wet-weather windproof jacket SAILING 100 navy blue
  • Waterproof sailing jacket - wet-weather windproof jacket SAILING 100 navy blue
  • Waterproof sailing jacket - wet-weather windproof jacket SAILING 100 navy blue
  • Waterproof sailing jacket - wet-weather windproof jacket SAILING 100 navy blue
  • Waterproof sailing jacket - wet-weather windproof jacket SAILING 100 navy blue
  • Waterproof sailing jacket - wet-weather windproof jacket SAILING 100 navy blue
  • Waterproof sailing jacket - wet-weather windproof jacket SAILING 100 navy blue
Color: BLUE
  • BLUE
  • BLUE / RED / COLORLESS
  • YELLOW
  • GREEN / BLUE
  • BLUE / RED
  • BLUE
  • GREEN / BLUE
Not available online

Store Availability

Store availability

close
Our designers—and fellow sailors— have developed this jacket for sailing in hot and stormy weather.

BENEFITS

Compact design

Compact, the jacket folds away into its hood

Water repellent

Especially treated so water slides off the fabric surface.

Resistance to salt water

Materials and zip fastenings resistant to salt water and sea air.

Windproof

Fabric especially coated to reduce the cooling effect of the wind.

Waterproof

Moderate rain for 2 hrs 5,000 mm Schmerber (JIS standard) Pockets not waterproof

Pockets

3 secure pockets, including 1 inner pocket

Breathability

Very breathable coated fabric (RET < 12): reduces condensation

TECHNICAL INFORMATIONS

Waterproofing 1/2

We measure the fabric resistance to water pressure in mm of water column (based on the JIS standard). The higher the water pressure withstood by the fabric, the more waterproof it is.

On our Sailing 100 jacket:

Component is resistant to water pressure of 5,000 mm Schmerber (JIS standard). This equates to the average pressure applied by the water during a rain shower.

The anorak's waterproofness was tested in a rain shower with 60 litres of water / m² / hour for 2 hours.

Waterproofing 2/2

- High collar

- Injection-moulded plastic to avoid salt oxidation

- Water-repellent components (water runs off the fabric)

- 100% taped seams

- Central opening features a flap with a drainage channel for optimal waterproofing

Hood

The hood does not pack down into the collar, it is attached.

Completely depth and height-adjustable hood.

Visor with a headband to provide a good level of protection and a better hold.

The high neck effectively protects the neck.

Pockets

2 zip pockets on the front of the jacket to put your hands or some items

1 inside pocket on the right side of the chest with a rip-tab closing

NOTE: the pockets are NOT WATERPROOF

Front zip closure

A zip on the entire jacket length with an interior flap protects against the wind and water.

Soft fabric flap on the top of the collar to protect the chin.

Fabric breathability

To find out whether a fabric is breathable, we test its evaporate resistance or RET (ISO 11092 standard). The lower the fabric's resistance, the more moisture is evaporated, and therefore the higher the fabric's breathability.

We consider that if:

RET < 9 = highly breathable fabric

9 < RET < 12 = breathable fabric

The RET of the Sailing jacket 100 is 12.

Water-repellent properties information

A fabric is water-repellent when water slides off the surface of the fabric, without seeping in.

Your jacket does not become waterlogged and remains lightweight and breathable. The water-repellent properties are achieved with a treatment applied to the external side of the fabric, but in practice these properties can be altered.

The water-repellent properties can be reactivated by putting the jacket in a dryer for 10 minutes at the lowest temperature.

How to wash your jacket?

To maintain the water repellent properties, infrequent washing is recommended.

Close all zips and flaps, empty all pockets and then turn the garment inside out to wash it. You can wash it on a synthetic cycle at 30°C or 40°C with your usual detergent. Do not use fabric conditioner, which could damage the existing performance of the garment, or bleach. Very important: choose a full-rinse cycle or extra rinse.

How to reactivate the anorak's water repellency

Drying is a crucial phase in reactivating the water repellent treatment.

We recommend that you lay your anorak flat on a clothes rack and leave it out to dry in the open. Caution: never dry your anorak directly on a radiator.

Then place it in the tumble dryer on a short synthetics cycle, i.e. 10 to 15 minutes, before turning it back the right way round. Caution: do not over-dry the garment.

COMPOSITION

composition

Upper part - Main fabric: 100.0% Polyamide; Lower part - Main fabric: 100.0% Polyamide; Main lining: 100.0% Polyester; Sleeve lining: 100.0% Polyester; Coating: 100.0% Polyurethane

Tips for storage and maintenance

MAXIMUM WASHING TEMPERATURE 30°C. NORMAL TREATMENT.

MAXIMUM WASHING TEMPERATURE 30°C. NORMAL TREATMENT.

BLEACHING EXCLUDED.

BLEACHING EXCLUDED.

DRYING IN TUMBLE DRYER POSSIBLE. LOW TEMPERATURE, MAXIMUM DRUM EXHAUST TEMPERATURE 60°C.

DRYING IN TUMBLE DRYER POSSIBLE. LOW TEMPERATURE, MAXIMUM DRUM EXHAUST TEMPERATURE 60°C.

DO NOT IRON.

DO NOT IRON.

DO NOT DRY CLEAN.

DO NOT DRY CLEAN.

TESTS AND WARRANTY

Warranty

2 Years

Ecodesign approach

With ecodesign, we reduce the environmental impact of our products.

Analysing the product's environmental footprint enabled us to identify the most impactful stages of its life cycle. Thanks to this approach, our design teams were able to develop this product while significantly reducing its environmental impact.

Ecodesign actions on this product
  • Picture showing Dope dyed
    Process

    Dope dyed

    Product made from 52% dope dyed yarn

    Using this mass-dyeing process enables us to reduce CO2 emissions linked to the production of dyed textiles by at least 17% compared to conventional dyeing.

 Learn more about our approach