Hybrid Football F500 Light Size 4 - Yellow

The story behind this ball

Our design team created this hybrid ball after observing football players in action on the pitch.

This ball is a hybrid because its design combines the comfort of a machine-stitched ball with the robustness of a hand-sewn one.

We also used a bladder with a special design (2 km of thread is wrapped around the bladder) to ensure lasting inflation and better sphericity.

Lighter than a regular ball

This ball is considered light because it is about 15% lighter than a regular size 5 football. What difference does that make? Thanks to its weight, young football players can kick or head the ball more comfortably. It's also easier to aim and execute long passes.

How big is it? What's the circumference?

The size of this ball is between 63.5cm and 64.5cm (size 4), and between 68.0cm and 70.0cm (size 5).

A "round" ball?

Here's how we test sphericity:

Average measured variation: 1.8% max (FIFA Basic certification).

We measure the football's sphericity at 4500 different points and then examine any differences.

If the discrepancy is greater than 1.8 % (FIFA Basic Standard), our engineers are tasked with improving the sphericity to ensure a consistent bounce.

Maximum pressure loss test: here's what we do...

Here's how we test pressure loss: We inflate the ball to the recommended pressure (meaning 0.8 bar).

72 hours later, the ball must not have lost more than 15% of its pressure, meaning approx. 0.1 bar (FIFA Basic certification). The pressure after 72 hours must, therefore, be at approx. 0.7 bar.

This also means that it is quite normal for a ball to lose pressure after a few days.

We've also tested how much water the ball absorbs...

Here's how we test water absorption:

We simulate rainy playing conditions in a lab, leaving the ball to sit in 2 cm of water on a pivoting support whilst subjecting it to 250 compressions.

At the end of the test, the ball must have absorbed no more than 10% of its weight (FIFA Basic certification).

It's all about the bounce

Here's the bounce test: The ball is dropped onto a steel plate 10 times from a height of 2 metres. The bounce height must be between 125 and 155 cm with a maximum difference of 10 cm between the ball's highest and lowest bounce.

Not even a scratch!

The most stringent test we put this ball through is the shooting machine test.

The ball must withstand 2500 shots against an inclined concrete surface at 50 km/h from a distance of 2.5 m.

At the end of the test, we check:

- the ball's general state: stitching must withstand this test

- the circumference: must not have increased by more than 1.5 cm.

- the sphericity: it must not have varied by over 1.8%

- the pressure: loss of pressure must not exceed 12.5%.

How about you? What do you think?

We value your feedback and use it to continuously improve our products.A huge thank you in advance for sharing your feedback with us.