Durability
Elbow and crotch reinforcements for better durability.
Outer reinforcement patches in high-wear areas.
To strengthen the joints, they are braided at sensitive points.
Melcro-taped: inner reinforcement of seams in delicate areas
Taped seams with a GBS glued and blind-stitched assembly.
The seams of the suit and hood are waterproof, with a glued and blind-stitched (GBS) assembly: the neoprene is glued first, then stitched for maximum strength (the needle does not completely pass through the neoprene to prevent water infiltration).
Limitation of water ingress
The ends of the wrists have silicone stoppers that limit water ingress. They also allow better support when using gloves.
Thermal comfort details.
Front-zip wetsuit jacket with 5 mm neoprene on the chest.
2.5 mm neoprene roll-up hood.
By trapping a thin layer of water around the body, a wetsuit works in two ways:
1-The trapped water gradually warms up
2-Heat transfer from the body decreases.
The suit and film of water form an insulating layer.
Once a thin film of water is trapped between your body and the jacket, no more water is able to circulate thanks to the Inner Stop Water inside the sleeves.
Multi-thickness
The wetsuit features 5 mm neoprene on the chest to guarantee thermal comfort.
4 mm on the sides and shoulders and 3 mm of Supratex on the sleeves, this multi-thickness has the comfort and ergonomics required for a canyoning suit
What is a wetsuit?
This is the most common type of wetsuit on the market. It is not designed to keep the water out but to trap it, so that your body then warms it up, creating a thermal buffer between you and the outside.
Made of neoprene - a rubber polymer filled with air bubbles - these wetsuits are available in thicknesses of 0.5 mm to 7 mm.
As such, they make excellent wetsuits because they are flexible and modular.
Tips for looking after your canyoning suit?
1/ After each session, soak the wetsuit in clean water, on the outside and the inside
2/ Use a bactericide solution to sanitise
3/ Rinse thoroughly in clean water
4/ Dry on a wide hanger in a well-ventilated place away from direct light. Keep away from direct sunlight as it can fade the fabric parts of the suit. The zips can be cleaned with a toothbrush.
Choose your size carefully
To make the most of the features of your wetsuit, it is necessary to choose the correct size. A canyoning wetsuit should be a very tight fit and there should be no visible folds. When dry, it is perfectly normal to feel like it is too tight, this discomfort disappears as soon as the wetsuit gets wet. If you choose a wetsuit that is too big, folds will appear, you will experience irritation and thermal insulation will be reduced (letting in water).
Keep warm
When we are in the water, we lose more than half of our body heat through our extremities (feet, hands, head).
In view of this, here are the recommended accessories:
- in warm water and temperate water (>17°C) => 3 mm neoprene low booties.
- in cold water (12°C - 17°C): 3 mm Gloves
- in very cold water (7°C - 12°C): Neoprene jacket, gloves and hood.
Find our entire range of accessories on our website